How to calculate a fuel surcharge, with a worked example at $6.13 diesel
Diesel is still above $6. Here's the formula, one sample load worked out step by step, and where your surcharge quietly falls short of your fuel bill.

Key points
- Formula: (weekly DOE diesel price − base price) ÷ MPG = fuel surcharge per mile. Then multiply by paid miles.
- At the EIA's $6.127 price for the week of Nov. 9, 2026, a $1.25 base and 6.5 MPG pays about 75¢ a mile.
- At 6.5 MPG, every 6.5¢ rise in diesel adds about 1¢ a mile. The same price on a 6.0 MPG table pays 81¢.
- Surcharges don't pay on deadhead and often assume better MPG than your truck gets. Check real fuel cost per load before booking.
To calculate a fuel surcharge in trucking, take the weekly DOE diesel price, subtract the base fuel price in your contract, and divide by the miles per gallon (MPG) the contract assumes. That gives you a surcharge per mile. Multiply it by the paid miles on the load. At the price for the week of November 9, 2026, a common $1.25 base and 6.5 MPG works out to about 75 cents a mile.
That one number can decide whether a load makes money. Diesel set a record of $6.529 a gallon the week of September 21, and it was still at $6.127 on November 9, according to FreightWaves' reading of EIA data. With fuel this high, a few cents of math can mean a few hundred dollars a load.
The formula in one line
Here it is:
(Current DOE diesel price − base price) ÷ MPG = fuel surcharge per mile
Then:
Fuel surcharge per mile × paid miles = fuel surcharge for the load
Here's what each part means:
- DOE diesel price. The weekly national average price for on-highway diesel. The EIA, the Department of Energy's statistics office, publishes it. Most rate cons and contracts point to this number.
- Base price. The diesel price that's already "baked into" your linehaul rate. Below it, you get no surcharge. Above it, the surcharge kicks in. Bases from $1.25 to $1.50 a gallon are common, per FreightWaves.
- MPG. The fuel mileage the formula assumes. Most tables use 6.0 to 6.5 MPG for a loaded Class 8 truck.
- Paid miles. The miles your customer pays for. Usually that's loaded miles only.
No federal rule sets the formula, the base or the MPG. They're whatever you and your shipper or broker agree to, so you can negotiate every part.
Where the DOE diesel price comes from
The EIA surveys retail truck stops and gas stations every Monday. It posts the result in its weekly Gasoline and Diesel Fuel Update that afternoon, or on Tuesday when Monday is a federal holiday. The easiest free place to see the full history, with regional prices, is the USDA's weekly on-highway diesel dataset. It reposts the EIA prices for the U.S. and each region every week, and you can chart or download them. The USDA's weekly Grain Transportation Report tracks the same EIA diesel price too.
Here's how the national price has moved lately (dollars per gallon):
- October 26, 2026: $6.352
- November 2, 2026: $6.292
- November 9, 2026: $6.127
For context, diesel averaged about $3.66 in 2025. At that price, the same $1.25 base and 6.5 MPG paid only 37 cents a mile. The surcharge has roughly doubled in a year. If your rates still look like 2025 rates, check how much of your pay is surcharge and how much is real linehaul.
A worked example, step by step
Say a broker offers you a 1,000-mile dry van load. The rate con says:
- Linehaul: $2.40 a mile ($2,400)
- Fuel surcharge: DOE national average, $1.25 base, 6.5 MPG, updated weekly on the Monday price
The load picks up the week of November 9, 2026, so you use $6.127.
Step 1: Find how far diesel is above the base. $6.127 − $1.25 = $4.877
Step 2: Divide by MPG. $4.877 ÷ 6.5 = $0.7503, which rounds to $0.75 a mile
Step 3: Multiply by paid miles. $0.75 × 1,000 = $750 fuel surcharge
Step 4: Add it to the linehaul. $2,400 + $750 = $3,150 total revenue
Now watch what the MPG number does. If you change only the MPG from 6.5 to 6.0, the surcharge becomes $4.877 ÷ 6.0 = $0.81 a mile. On this load, that's $810 instead of $750. You get $60 more for the same truck and the same miles. A lower MPG in the table pays the carrier more, and a higher one pays less. If a customer's table assumes 7 MPG, ask why.
Fuel surcharge table at a $1.25 base and 6.5 MPG
A fuel surcharge table runs the formula ahead of time for a range of diesel prices. This one uses the terms from the example above.
| DOE diesel price ($/gal) | Surcharge per mile | Surcharge on a 1,000-mile load |
|---|---|---|
| $3.50 | $0.35 | $350 |
| $4.00 | $0.42 | $420 |
| $4.50 | $0.50 | $500 |
| $5.00 | $0.58 | $580 |
| $5.50 | $0.65 | $650 |
| $6.00 | $0.73 | $730 |
| $6.127 (week of Nov. 9, 2026) | $0.75 | $750 |
| $6.50 | $0.81 | $810 |
A quick rule of thumb: at 6.5 MPG, every 6.5-cent rise in diesel adds about 1 cent a mile. At 6.0 MPG, every 6-cent rise adds a penny. Many shippers print their tables in price "bands" like this instead of exact math. That's fine, as long as the band size matches the MPG they claim.
Some customers, mostly LTL (less-than-truckload) shippers, quote the surcharge as a percent of linehaul instead of cents per mile. You can convert one to the other. In our example, $0.75 ÷ $2.40 is about 31% of linehaul.
Where the surcharge falls short of your real fuel bill
This is the part most carriers miss. The surcharge comes from a formula, while your fuel bill comes from real driving. The two rarely match.
Go back to the 1,000-mile load and add what actually happens:
- You drive 100 empty miles to the shipper. That deadhead isn't paid, so it earns no surcharge.
- Your truck averages 6.2 MPG, not 6.5.
- Your fuel card shows you paid $6.25 a gallon on average. The Midwest regional price that week was $6.201, a bit above the national number.
Your real fuel cost: 1,100 miles ÷ 6.2 MPG = about 177 gallons. 177 gallons × $6.25 = about $1,109.
What the load paid you for fuel:
- The surcharge: $750
- The fuel already "in" the linehaul at the $1.25 base: 1,000 ÷ 6.5 × $1.25 = about $192
- Total: about $942
That leaves a gap of about $167. It comes straight out of your linehaul, before you pay the driver, the truck note or insurance. At four loads a week per truck, it adds up fast.
That's why the surcharge alone can't tell you whether a load is good. You need your real cost per mile, including fuel at your actual MPG and pump price. If you haven't worked yours out lately, our guide on how to calculate cost per mile walks you through it.
The fix is to price every load on what you will spend, not on what the formula pays. TorqueAI brings your fuel card transactions and loads into one system. That way you see real profit per load, per truck and per lane instead of guessing at the end of the month. See how that works on our page about knowing your profit per load before you book it.
Should you use the national or regional DOE price?
The EIA publishes a national average plus prices for each region (it calls the regions PADDs). The gap between them can be real money. For the week of November 2, 2026, the EIA had the Gulf Coast at $5.912 and the Midwest at $6.402. That's 49 cents a gallon apart, or about 7.5 cents a mile at 6.5 MPG.
A simple way to think about it:
- If you mostly fuel in a high-price region, ask for that region's index or a lower base.
- If you mostly fuel in a cheaper region, the national average may help you.
- Whatever you pick, write it into the contract. "DOE" alone isn't specific enough.
Also agree on which week's price applies. Most contracts use the Monday price for the week of pickup, but some use the week before. When diesel moves more than 16 cents in a week, as it did from November 2 to November 9, that choice changes the bill.
How to read an all-in rate before you say yes
Brokers often quote "all-in" rates on load boards. That number already includes fuel. To compare it fairly, take the surcharge out.
Say a broker offers $3,000 all-in for the same 1,000 miles. At this week's price, about $750 of that is fuel. So the real linehaul is $3,000 − $750 = $2,250, or $2.25 a mile. That's 15 cents a mile less than the first offer, even though $3,000 sounds like a strong number.
Do this math every time. Diesel was under $3.50 in January 2026. An all-in rate that worked then could be a losing load now.
Canadian and cross-border loads
Canadian carriers usually price fuel in cents per litre. Natural Resources Canada tracks weekly retail diesel prices across the country. As of November 2, 2026, its national average was about 260.2 cents a litre, taxes included.
If your surcharge table is in litres, the math is the same. The base price and fuel economy just need to be in the same units. One US gallon is 3.785 litres, so a truck getting 6.5 miles per gallon gets about 1.72 miles per litre.
On cross-border freight, put three things in writing: which index (EIA or NRCan), which currency, and whether the surcharge applies to all miles or only miles in one country. Mixed-up units and currencies can lead to short-paid invoices. Our cross-border trucking software page covers how to keep Canadian and US loads in one place.
Five things to put in every rate agreement
Before you sign a contract or accept a rate con with a surcharge, check these five things:
- The index. National or a named region, and EIA or NRCan.
- The base price. Lower is better for you.
- The MPG. 6.0 to 6.5 is normal. Push back on anything higher.
- The timing. Which Monday price applies, and how often it updates.
- The miles. Loaded only or all miles, and which mileage source.
Keep your fuel receipts tied to each load, too. The gallons and miles you use to check your surcharge also go into your quarterly fuel tax report. If that's your job, see our breakdown of IFTA filing deadlines and the data you need.
Questions readers ask
How do you calculate a fuel surcharge for trucking?+
Take the weekly DOE (EIA) on-highway diesel price and subtract the base fuel price in your contract. Then divide by the MPG the contract assumes. That gives you the surcharge per mile. Multiply it by the paid miles on the load to get the total surcharge.
What is the DOE diesel price and when does it come out?+
It's the national average retail price for on-highway diesel, published by the U.S. Energy Information Administration (EIA). The EIA surveys stations every Monday and posts the price that afternoon, or on Tuesday after a Monday federal holiday. For the week of November 9, 2026, it was $6.127 a gallon.
What base price and MPG should I use in a fuel surcharge table?+
Most truckload tables use a base price of about $1.25 to $1.50 a gallon and assume 6.0 to 6.5 MPG. No federal rule sets these numbers, so they're negotiable. A lower base and a lower MPG both pay the carrier more surcharge.
Should my fuel surcharge use the national or regional DOE price?+
Use the price that best matches where your trucks actually fuel. The EIA publishes a national average and regional (PADD) prices. As of early November 2026, those were almost 50 cents a gallon apart. Whatever you choose, name the exact index in your contract.
How do Canadian carriers calculate a fuel surcharge?+
The formula is the same, but prices are usually in cents per litre. Natural Resources Canada publishes weekly retail diesel prices, and the national average was about 260.2 cents a litre as of November 2, 2026. Keep the base price and fuel economy in the same units (one US gallon is 3.785 litres), and name the index and currency in writing.



